Cable Outlet Gland

1. Place the cable outlet drill template in the required position on the elevated trough.
2. Drill fastener and outlet holes as marked on the template.
3. Deburr the cable penetration with a file or sandpaper to remove any sharp edges or fibres.
4. Install the Cable Outlet at the desired location on the elevated trough base using the supplied bolts (M8x16 – fig. 9). Ensure that the bolt’s mushroom head is located inside the cable duct.

Caution: If adding a conduit, ensure that it has the same or higher fire protection rating as the Elevated Trough.

Additional Tooling Required:

• Drill
• 7mm Drill Bit
• 70mm Hole Cutter
• Allen Key
• 10mm Spanner

Special Components

Special consoles are used to run a cable route over engineering structures (bridges, overpasses, viaducts, etc.).

• Prior to installation, determine the shape of the poles (round, square, or rectangular tube, angled profile, etc.) and their dimensions as well as spacing.

Coupler Kit

A coupler kit can be provided to meet special requirements.